EN10083-2: C45,C45E steel works/steel structures/steel machining parts

The chemical composition of EN10083-2: C45( material NO.: 1.0503)
C: 0.42-0.5, Si: 0.4, Mn: 0.5-0.8, P: 0.045, S: 0.045, Cr: 0.4, Mo: 0.1, Ni: 0.4
The chemical composition of EN10083-2: C45E(material NO.: 1.1191) steel:
C: 0.42-0.5, Si: 0.4, Mn: 0.5-0.8, P: 0.03, S: 0.035, Cr: 0.4, Mo: 0.1, Ni: 0.4
Mechannical Properties in quenching and tempering condition (room temperature):
C45: diameter≤16mm or thickness≤8mm:
Tensile strength  σb (MPa)：700-850
Yield strength  σs (MPa)：≥490
Elongation  δ5 (%)：≥14
C45: 16mm < diameter≤40mm or 8mm < thickness≤20mm:
Tensile strength  σb (MPa)：650-800
Yield strength  σs (MPa)：≥430
Elongation  δ5 (%)：≥16
C45: 40mm < diameter≤100mm or 20mm < thickness≤60mm:
Tensile strength  σb (MPa)：630-780
Yield strength  σs (MPa)：≥370
Elongation  δ5 (%)：≥17
Recommended temperature in heat treatment: Normalizing: 850℃，Quenching：840℃， tempering 600℃
C45 steel is a kind of high strength, high quality carbon steel. It is usually used in normalized condition because of weak harden-ability. It will be tempered when it has high requirements for mechanical properties. C45 steel is usually made to components which need high strength, such as gear, shaft, piston pin, etc. It is also used for mechanical parts, forging, stamping parts, bolts, nuts and pipe joints.
KUNFENG is located in Pudong district of Shanghai city. It is only 30 minutes from Pudong International airport to our company. If you need C45 or C45E steel rod/round bar, steel plate, steel pipe, please check with us. We have plenty of stock. And also we can provide the process and machining service. So we can offer the C45 and C45E steel works, steel structures and steel machining parts, we sincerely invite you to visit us. We will pick you up at the airport if you tell us your schedule.